1
1
2
1
0
1
0
0
1
1
1
0
0
0
0
0
1
2
1
1
2
1
1
1
Mileage filter for BMW: information regarding the installation and operation.
The mileage filter for freezing mileage for BMW works on all models of the F, and G series. The devices stop the mileage counter completely or “filter” up to 90% of the mileage (depends on the car's Dashboard model, selected Mode, and ECU firmware).
✔️ The installation of the filter on any BMW model is quite simple and you can do it yourself
✔️ All electronic units will display the same mileage information
✔️ Removing the mileage filter will not affect the data
ACTIVATION
Most of the kilometer blocker bmw come pre-activated upon the install. If you installed the device and mileage continues to go up, please refer to the "Modes" section below.
MODES
To switch a mode, press and hold the "BC" button on the left control lever either for 5 or 10 seconds. Modes are switched successively. Mode switching is confirmed by the flashing of a hazard light.
1 — (for Dashboards 6WA and 6WB, 2010-2019): Speedometer works normally / Mileage is stopped completely.
NB: This mode only works with vehicles BMW that are not updated with 2019 ECU firmware.
2 — (for Dashboards 6WA and 6WB, 2010-2019): Speedometer works normally / Mileage is filtered at 90% (e.g. 100 miles will be counted as 10).
3 — (for Dashboards S6U3A): Speedometer works at 50% (e.g. 100 MPH will be shown as 50) / Mileage is blocked by 50% (e.g. 100 miles will be counted as 50).
4 — (for Dashboards S6U3A): Speedometer works at 25% (e.g. 100 MPH will be shown as 25) / Mileage is filtered at 75% (e.g. 100 miles will be counted as 25).
5 — (for Dashboards S6U3A): Speedometer works at 10% (e.g. 100 MPH will be shown as 10) / Mileage is filtered at 90% (e.g. 100 miles will be counted as 10).
6 — (for Dashboards S6U3A): Speedometer does not work / Mileage is completely stopped.
7 — Switch OFF (everything comes back to normal).
Where is the odometer reset button BMW?
To reset the trip odometer use the BC button on the turn indicator lever. Short press the BC button to toggle between the different widgets and info displays till you see a journey data line. Long press the BC button on the tour indicator to reset the trip odometer / journey data.