Genesis odometer correction tool
Genesis: information regarding the installation and operation.
Mileage Stopper is a new approach to working with Genesis odometer data.
Our mileage filters for Genesis works on all models manufactured from 2016 till present. The devices are very similar to those that are used on Hyundai cars, mainly because it’s basically is the same manufacturer.
✔️ The device is installed behind the dashboard and the process usually takes about half and hour minutes. A help from a certified technician is recommended because of all the expensive leather and trims.
✔️ Removing the filter will not affect the current mileage data.
Most of the devices come pre-activated upon the install. If you installed the mileage stopper for Hyundai Genesis and mileage continues to go up, please refer to the "Modes" section below.
Stopping mileage on Genesis vehicles tend to depend on the Speedometer model and ECU firmware version. Thus, to complement each car model, we developed several Modes that are available with each device. Some modes may work best for your car, and some may not.
1. 50/50 Mode. The speedometer works at 50% (e.g. 100 MPH will be shown as 50 MPH) — 50% of mileage is filtered (e.g. 100 miles will be counted as only 50 miles).
2. 25/50 Mode. The speedometer works at 25% (e.g. 100 MPH will be shown as 25 MPH) — 75% of mileage is filtered (e.g. 100 miles will be counted as only 50 miles).
3. 0/100. The speedometer will not work at all — 100% of mileage is filtered (e.g. 100 miles will be counted as 0).
4. Turn OFF.