The device “filters” up to 80% of the mileage or stops the mileage counter completely (depends on the mode selected). There are 5 modes, that are designed for different ECUs.

Programs are switched successively: to switch a mode, you need to press and hold the "back" button on the left side of the steering wheel for 10 seconds.

On some VAG models you need to press the “OK” button on the right side of the steering wheel (looks like a small “wheel” switch), or the lower button “OK/Reset” button on the right wiper lever.

MODES:

1—Speedometer works normally / 75% of mileage is filtered (e.g. 100 miles will be counted as 25).

2—Speedometer works normally / 80% of mileage is filtered (e.g. 100 miles will be counted as 20).

3—Speedometer does not work / 100% of mileage is blocked (e.g. 100 miles will be counted as 0).

4—Turn OFF (everything comes back to normal).

Mode switching is confirmed by the flashing of a hazard light.

Activation:

Mode 1 is activated by default immediately after installation. No need to activate the device.

Installation: 

The device is installed behind the dashboard. Installation takes about 30 minutes and it's possible to do it on your own.

Note: Removing the device will not affect the mileage data (the mileage will not jump up).

Note: the device stops all VAG vehicles from counting the distance to the next oil change (the service counter is stopped).

Our devices work on all Volkswagen cars manufactured from 2014 till present.