The mileage stopper works on all AUDI cars manufactured from 2014 till present.

Note: The device stops all VAG vehicles from counting the distance to the next oil change (the service counter is stopped).

Installation

The device is installed behind the dashboard. Installation takes about 30 minutes and it's possible to do it on your own.

✔️ Uninstalling the device will not affect the mileage data (the mileage will not jump up).

Activation

Mode 1 is activated by default immediately after installation. No need to activate the device.

Programs are switched successively: to switch a mode, you need to press and hold the "back" button on the left side of the steering wheel for 10 seconds.

On some VAG models you need to press the “OK” button on the right side of the steering wheel (looks like a small “wheel” switch), or the lower button “OK/Reset” button on the right wiper lever.

MODES:

1—Speedometer works normally / 70% of mileage is filtered (e.g. 100 miles will be counted as 30).

2—Speedometer works normally / 80% of mileage is filtered (e.g. 100 miles will be counted as 20).

3—Turn OFF (everything comes back to normal).

Mode switching is confirmed by the flashing of a hazard light.

There is also a mode that allows you to completely stop the mileage, but the speedometer arrow will not work if it is used.